定值DNP電流故死區必須設為“15”。注意，這些定值是死區默認值。對于每一個DNP模擬輸入點，DNP目標34點可以用來改變死區值。無論何時，掉電時或C60重新應用時,默認死區將會起作用。DNP時間同步IN周期定值決定C60設置必須的內在指示時間(IN)的頻率。這個時間的改變?cè)试S

Modicon AS-C924-000 24-Bit CPU Module (AS-IS)

IDT 92-00132 Keyboard (UVG)

Texas Instruments PM550-210 Power Supply (AS-IS)

Modicon AS-506P-008 CPU Board 584A 8K (AIND/UVG)

Modicon AS-521P-111 CNC Memory Board Rev A (AS-IS)

Modicon AS-884A-111 Processor Module AS884A111 (UVG)

Unico 307-717 Memory/Processo?r Board, Rev 2 (AS-IS)

GE Fanuc IC600CB525K Advanced Logic Control Board (UVG)

Allen Bradley 1775-MR4 CMOS RAM Memory Module (AS-IS)

WTC (Welding Technology Corp.) U60-T95A Control (UVG)

Toshiba VT130G3U4035 G3 Tosvert-130 Inverter 3HP (UGC)

Banner MUSC-1S6-02906 Light Curtain Controller (UEX)

Banner MUSC-1S6-02906R Light Curtain Controller (UEX)

Siemens 6SE1200-7AA10-3 SIMOREG 6RA Keypad Unit (UGC)

Modicon AS-521P-008 CNC Memory Board (AIPR/UGC)

Allen Bradley 8500-E154/A I/O Block Assy, Ser A (AS-IS)

Modicon/Gould AS-P190-112 PLC Programmer (UGC)

Modicon/Gould AS-P190-212 PLC Programmer (UGC)